Operation CHARM: Car repair manuals for everyone.
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Seat Occupant Sensor: Service and Repair




Front Passenger's Weight Sensor Replacement

Removal

NOTE: Removal of the front passenger's weight sensors must be performed according to the precautions/procedures described at the beginning of the SRS. Technician Safety Information

1. Do the battery terminal disconnection procedure, Procedures then wait at least 3 minutes before starting work.

2. Remove the front passenger's seat assembly. Front Seat Removal/Installation

3. Remove the tamper-resistant TORX bolts (A) attaching the seat track (B) and seat riser (C) to the weight sensors (D).

4. Disconnect the sensor connectors (E) from the ODS unit harness connectors, then remove the front passenger's weight sensors.






Installation

NOTE: Be sure to install the harness wires so they are not pinched or interfering with other parts.

1. Install the front passenger's weight sensors with TORX bolts (A, B, C) under the seat track.

2. Reinstall the front passenger's seat. Front Seat Removal/Installation

3. Do the battery terminal reconnection procedure. Procedures

4. Clear the any DTCs. Initial Inspection and Diagnostic Overview

5. Calibrate the ODS unit. Programming and Relearning

6. After installing the front passenger's weight sensors, confirm proper system operation: Turn the ignition switch to ON (II); the SRS indicator should come for about 6 seconds and then go off.