Operation CHARM: Car repair manuals for everyone.
Home >> Honda >> 2010 >> CR-V 2WD L4-2.4L >> Repair and Diagnosis >> Restraints and Safety Systems >> Air Bag Systems >> Seat Occupant Sensor >> Service and Repair
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Seat Occupant Sensor: Service and Repair




Front Passenger's Weight Sensor Replacement

Removal

NOTE:

- Removal of the front passenger's weight sensors must be performed according to the Precautions and Procedures Service and Repair.
- The front passenger's weight sensor are part of the seat rail and must be replaced as an assembly.

1. Do the battery terminal disconnection procedure Procedures, and wait at least 3 minutes before beginning work.

2. Remove the front passenger's seat Front Seat Removal/Installation.

3. Remove the seat cushion cover/pad from the seat cushion frame Front Seat Cushion Cover/Pad Replacement.

4. Remove the TORX nuts (A) attaching the seat track (B) to the weight sensors (C) using a TORX E18 socket.





5. Disconnect the sensor connectors (D) from the seat weight sensor, then remove the front passenger's seat slide assembly (E) including all four front passenger's weight sensors.

Installation

NOTE:

- Make sure to install the harness wires so they are not pinched or interfering with other parts.
- A spacer has front and back faces. Be sure to install the spacer correctly.

1. Install the new front passenger's seat slide assembly under the seat track.










2. When tightening the TORX nuts (A), begin with (1), and tighten them in a crisscross pattern in two or more steps.





3. Torque the TORX nuts in the sequence shown in two or more steps.

4. Reassemble the front passenger's seat cushion cover/pad Front Seat Cushion Cover/Pad Replacement.

5. Reinstall the front passenger's seat Front Seat Removal/Installation.

6. Do the battery terminal reconnection procedure Procedures.

7. Clear any DTCs with the HDS Reading and Clearing Diagnostic Trouble Codes.

8. Do the front passenger's weight sensor initialization Programming and Relearning.

9. Confirm proper SRS operation: Turn the ignition switch to ON (II), and check that the SRS indicator comes for about 6 seconds and then go off.

pro multis · About Operation CHARM