Safing Sensor: Service and Repair

Rear Safing Sensor Replacement

Removal

1. Do the battery terminal disconnection procedure Procedures, then wait at least 3 minutes before starting work.

2. Remove the rear seat cushion.

3. Disconnect the SRS floor wire harness 2P (4-door) or 4P (2-door) connector (A) from the rear safing sensor (B).





4. Remove the TORX bolt (C) using a TORX T30 bit, then remove the rear safing sensor.

Installation

1. Install the rear safing sensor (A) with the new TORX bolt (B), using a TORX T30 bit. Connect the SRS floor wire harness 2P (4-door) or 4P (2-door) connector (C) to the rear safing sensor.





2. Do the battery terminal reconnection procedure Procedures.

3. Clear any DTCs with the HDS.

4. Confirm proper SRS operation: Turn the ignition switch to ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off.

5. Reinstall all removed parts.