Operation CHARM: Car repair manuals for everyone.
Home >> Honda >> 2012 >> CR-V 2WD L4-2.4L >> Repair and Diagnosis >> Brakes and Traction Control >> Antilock Brakes / Traction Control Systems >> Wheel Speed Sensor >> Service and Repair >> Rear Wheel Speed Sensor Removal And Installation
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Rear Wheel Speed Sensor Removal And Installation






Rear Wheel Speed Sensor Removal and Installation

Removal

1. Vehicle Lift

1. Raise the vehicle on a lift, and make sure it is securely supported.

2. Rear Wheel





1. Remove the rear wheel.

3. Rear Wheel Speed Sensor

1. Turn the ignition switch to LOCK (0).

2. Release the connector holding clamps (A).






3. Disconnect the connector (B).

4. Remove the clips (C).

5. Remove the wheel speed sensor (D).

Installation

1. Rear Wheel Speed Sensor

1. Install the wheel speed sensor (A).

NOTE:
* Do not twist the sensor wires.

* If the wheel speed sensor comes in contact with the wheel bearing, it is faulty.

* Make sure there is no debris in the sensor mounting hole.






2. Install the harness clips (B).

3. Connect the connector (C).

4. Connect the connector holding clamps (D).

2. Rear Wheel





1. Install the rear wheel.

NOTE: Before installing the wheel, clean the mating surfaces between the brake disc/drum and the inside of the wheel.
pro multis · About Operation CHARM