Rear Power Window Motor Test

Rear Power Window Motor Test

Motor Test

1. Remove the rear power window switch Rear Power Window Switch Removal And Installation.

2. Test the motor in each direction by connecting battery power and ground to the rear power window switch 8P connector according to the table.









3. If the motor does not run or fails to run smoothly, go to step 4.

4. Remove the door panel Service and Repair.

5. Disconnect the 2P connector from the rear power window motor.

6. Check for continuity between the rear power window switch 8P connector terminals and rear power window motor 2P connector terminals as shown. There should be continuity.

Left side










Right side









7. If there is no continuity, repair an open or high resistance in the wire(s). If the wire harness is OK, faulty rear power window motor; replace the rear door regulator Service and Repair.