Warm Up TWC Removal and Installation

Warm Up TWC Removal and Installation





Removal

1. Wiper Arm Assembly





NOTE: Set the wiper arms to the auto-stop position before removal.

1. Remove the cowl top wiper covers (A).

2. Remove the wiper arms (B).

2. Both Side Cowl Covers





1. Remove the side cowl cover (A).

2. The left side is shown; repeat on the right side.

3. Center Cowl Cover





1. Remove the center cowl cover (A).

2. Disconnect the windshield washer tube (B).

3. If necessary, remove the hood rear seal (C).

4. Under Cowl Panel





1. Remove the under cowl panel (A).

5. A/F Sensor





1. Disconnect the connector.

2. Remove the A/F sensor (A).

6. Exhaust Chamber Cover





1. Remove the exhaust chamber cover (A).

7. Vehicle Lift

1. Raise the vehicle on a lift, and make sure it is securely supported.

8. WU-TWC





1. Remove the WU-TWC (A).

2. Remove the WU-TWC cover (B).

Installation

1. WU-TWC





1. Install the WU-TWC cover (A).

2. Install the WU-TWC (B) with new gaskets (C).

2. Exhaust Chamber Cover





1. Install the exhaust chamber cover (A).

3. A/F Sensor





1. Install the A/F sensor (A).

2. Connect the connector.

4. Under Cowl Panel





1. Install the under cowl panel (A).

5. Center Cowl Cover





1. If necessary, install the hood rear seal (A).

2. Connect the windshield washer tube (B).

3. Install the center cowl cover (C).

6. Both Side Cowl Covers





1. Install the side cowl cover (A).

2. The left side is shown; repeat on the right side.

7. Wiper Arm Assembly





NOTE: Set the wiper arms to the auto-stop position before installation.

1. Install the wiper arms (A).

2. Install the cowl top wiper covers (B).