Speaker Test/Replacement

Speaker Test/Replacement

Door Speaker

1. Remove the door panel.

- Front Service and Repair
- Sliding door Service and Repair

2. Remove the bolt (A). Then lift the speaker (B) straight up to release the lower clips (C).

NOTICE
If you pull the speaker out too far from the door, you will damage the lower clips.





3. Disconnect the connector (D), and remove the speaker.

4. Measure the resistance between speaker 2P connector terminals No. 1 and No. 2. There should be about 4 Ohms.

5. If the resistance is not as specified, replace the door speaker.

Tweeter

1. From the notch (A), carefully pry the tweeter grille (B) out with a small screwdriver. Be careful not to damage the tweeter grille and the dashboard.





2. Disconnect the connector (C) from the tweeter.

3. Remove the tweeter (A) from the tweeter grille (B).






4. Measure the resistance between the tweeter (A) terminals as shown.

- With navigation: Measure the resistance between the tweeter 2P connector terminals No. 1 and No. 2. There should be about 3.3 Ohms.
- Without navigation: Measure the resistance between terminal No. 1 and the outside terminal of the capacitor (B). There should be about 4 Ohms. Also check the capacitor condition. If any problem is found, replace the tweeter.

With navigation





Without navigation





5. If the resistance is not as specified, replace the tweeter.

Front Center Speaker

1. From the notch (A), carefully pry the speaker grille (B) out with a small screwdriver, then disconnect the connectors. Be careful not to damage the speaker grille and the dashboard.






2. Remove the screws and the front center speaker (A).





3. Measure the resistance between terminals No. 1 and No. 2. There should be about 4 Ohms.

4. If the resistance is not as specified, replace the front center speaker.

Satellite Speaker

SRS components are located in this area. Review the SRS component locations Locations, and the precautions and procedures Service Precautions before doing repairs or service.

1. Remove the D-pillar trim.

2. Remove the screws and the satellite speaker (A).





3. Measure the resistance between terminals No. 1 and No. 2. There should be about 4 Ohms.

4. If the resistance is not as specified, replace the satellite speaker.

Roof Speaker

NOTE:

- Put on gloves to protect your hands.
- Take care not to scratch the headliner and display cover.

1. Remove the wireless remote control.

2. Remove the display cover (A).






3. Remove the screws, and disconnect the connector (A), then remove the roof speaker (B).





4. Measure the resistance between terminals No. 1 and No. 2. There should be about 4 Ohms.

5. If the resistance is not as specified, replace the roof speaker.

Subwoofer

1. Remove the left rear side trim panel Interior Trim Removal/Installation - Rear Side Area.

2. Remove the bolts (A) and the nuts (B) from the subwoofer (C).





3. Disconnect the connector (D), then remove the subwoofer.

4. Measure the resistance between the terminals No. 1 and No. 2. There should be about 2 Ohms.

5. If the resistance is not as specified, replace the subwoofer.