Front Impact Sensor Replacement

Front Impact Sensor Replacement

Removal

1. Do the battery terminal disconnection procedure, then wait at least 3 minutes before starting work.

2. Remove the front inner fender Front Inner Fender Replacement.

3. Disconnect the front impact sensor 2P connector (A) on the left or right engine compartment wire harness.






4. Remove the TORX bolt (B) using a TORX T30 bit, then remove the front impact sensor (C).

Installation

1. Install the front impact sensor (A) with the new TORX bolt (B) using a TORX T30 bit, and tighten the TORX bolt to the specified torque.





2. Connect the front impact sensor 2P connector (C) on the left or right engine compartment wire harness.

3. Do the battery terminal reconnection procedure.

4. Clear any DTCs with the HDS.

5. Confirm proper SRS operation: Turn the ignition switch to ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off.

6. Install the front inner fender Front Inner Fender Replacement.