Rear Power Window Motor Test

Rear Power Window Motor Test

1. Remove the rear power window switch panel Rear Power Window Switch Test/Replacement.

2. Test the motor in each direction by connecting battery power and ground to the rear power window switch 14P connector (A) according to the table.










3. If the motor does not run or fails to run smoothly, go to step 4. If the motor runs smoothly, do the rear power window switch test Rear Power Window Switch Test/Replacement.

4. Remove the door panel Service and Repair.

5. Disconnect the 2P connector (A) from the rear power window motor (B).






6. Check for continuity between the rear power window switch 14P connector terminals and rear power window motor 2P connector terminals as shown. There should be continuity.









*1: Left rear power window
*2: Right rear power window

7. If the wire harness is OK, the rear power window motor is faulty; replace the rear power window motor Service and Repair.