Parking Lamp: Service and Repair
PARK/TURN SIGNAL LAMP REPLACEMENTREMOVAL PROCEDURE
1. Remove the grille.
2. Open the hood.
3. Remove the retaining nuts.
4. Remove the electrical harness.
5. Disengage the retaining clips.
6. Close the hood.
7. Remove the lamp.
8. Remove the bulb socket by turning the socket counterclockwise.
9. Remove the bulb.
INSTALLATION PROCEDURE
1. Install the bulb.
2. Install the bulb socket by turning the socket clockwise.
3. Install the lamp.
4. Open the hood.
5. Engage the retaining clips.
6. Install the electrical harness.
NOTE: Refer to Fastener Notice in Service Precautions.
7. Install the retaining nuts.
Tighten
Tighten the nuts to 6 N.m (53 lb in).
8. Close the hood.
9. Install the grille.