Operation CHARM: Car repair manuals for everyone.
Home >> Hummer >> 2004 >> H2 V8-6.0L >> Repair and Diagnosis >> Starting and Charging >> Power and Ground Distribution >> Fuse Block >> Service and Repair >> I/Panel Electrical Center or Junction Block Replacement - Right
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

I/Panel Electrical Center or Junction Block Replacement - Right

INSTRUMENT PANEL ELECTRICAL CENTER OR JUNCTION BLOCK REPLACEMENT - RIGHT

REMOVAL PROCEDURE




1. Remove the right side end panel.
2. Push in the tabs in order to remove the fuse block.
3. Pull out the fuse block out of the I/P in order to remove the retaining bolt.
4. Loosen the bolt.
5. Insert a screw driver between the wire harness block and fuse block in order to separate.
6. Separate the fuse block from the I/P harness block.
7. Remove the IP wiring harness block from the vehicle.

INSTALLATION PROCEDURE




1. Install the fuse block to the I/P wire harness block.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the retaining bolt.

Tighten
Tighten the bolt to 6 N.m (53 lb in)

3. Install the fuse block to the I/P till it clicks in place.




4. Connect the wiring connectors to the fuse block.
5. Install the right side end panel.
pro multis · About Operation CHARM