Throttle Body: Service and Repair

Throttle Body Assembly Replacement

Removal Procedure




1. Remove the air cleaner resonator and outlet duct.
2. Disconnect the evaporative emission (EVAP) canister purge pipe (1) from the throttle control module (2).




3. Disconnect the throttle body electrical connector (2).




4. Remove the throttle body bolts (1).
5. Remove the throttle body (2) and the seal from the intake manifold.
6. Clean the gasket surface.

Installation Procedure




1. Insert a new seal into the intake manifold groove.
2. Position the throttle body (2) to the intake manifold.

Notice: Refer to Fastener Notice.

3. Install the throttle body bolts (1).

Tighten the bolts to 10 N.m (89 lb in).




4. Connect the throttle body electrical connector (2).




5. Connect the EVAP canister purge pipe (1) to the throttle control module (2).
6. Install the air cleaner resonator and outlet duct.