Fog/Driving Lamp: Adjustments

Off Road Lamp Adjustment

Adjustment Procedure

1. Insert the flat, angled end of the adjustment wrench into the depressions on the outboard edges of the covers.
2. Gently press forward to pry the covers off.
3. With the covers off and the roof lamps off, insert a 10 mm hex wrench between the outboard edge of the lamp and housing onto the adjustment screw.
4. Loosen the adjustment screw.
5. Rotate the lamp up or down to the desired position.
6. Tighten the adjustment screw.
7. Inspect the backside of the cover for RH or LH designation molded into the plastic. the RH cover goes on the passenger side and the LH goes on the driver side.
8. Slide the end with the long hook and O-ring into the lamp housing on the inboard side of the lamp.
9. Press the end with the two short tabs into the outboard side until you hear an audible snap.