Ignition Lock Cylinder Case Replacement

Ignition Lock Cylinder Case Replacement

Removal Procedure

Caution: Refer to SIR Caution (SIR Caution) .
1. Disable the supplemental inflatable restraint (SIR) system. Refer toSIR Disabling and Enabling (Service and Repair) .
2. Remove the ignition lock cylinder. Refer to Ignition Lock Cylinder Replacement (Ignition Lock Cylinder Replacement) .
3. Remove the multifunction turn signal switch housing. Refer to Multifunction Turn Signal Switch Housing Replacement (Multifunction Turn Signal Switch Housing Replacement) .




4. Remove the ignition lock cylinder case bolt using a hammer and chisel.
5. Remove the ignition lock cylinder case.



Installation Procedure





1. Install the ignition lock cylinder case.

Notice: Refer to Fastener Notice (Fastener Notice) .

2. Install a new ignition lock cylinder case bolt and turn it until the head shears off.
3. Install the multifunction turn signal switch housing. Refer to Multifunction Turn Signal Switch Housing Replacement (Multifunction Turn Signal Switch Housing Replacement) .
4. Install the ignition lock cylinder. Refer to Ignition Lock Cylinder Replacement (Ignition Lock Cylinder Replacement) .
5. The Passlock sensor is part of the ignition switch. If replacing the switch, a theft deterrent relearn is needed. Refer to Control Module References (Programming and Relearning) .
6. Enable the SIR system. Refer to SIR Disabling and Enabling (Service and Repair) .