Compass Mirror

Adjustment

Calibration Procedure
If the display read "C", calibrate the compass.
1. Driving the vehicle in a circle at less than 8km/h 3 times or until the compass heading appears.
2. Driving in a circle in right-handed direction and opposite direction are possible, and if the calibration is completed, the compass heading will appear.
3. Keep driving in a circle until a compass heading appears.

To Adjust The Zone Setting :
1. Determine the desired zone number based upon your current location on the zone maps.
2. Press and hold the Feature Control button for more than 6 but less than 9 seconds, the current zone number will appear on the display (B).
3. Pressing and holding the feature control button (A) again will cause the numbers to increment (Note: they will repeat ...13, 14, 15, 1, 2,.). Releasing the button when the desired zone number appears on the display will set the new zone.
4. Within about 5 seconds the compass will start displaying a compass heading again.

To Re-calibrate The Compass :
There are some conditions that can cause changes to the vehicle magnets. Items such as installing a ski rack or a antenna or even some body repair work on the vehicle can cause changes to the vehicle's magnetic field. In these situations, the compass will need to be re-calibrated to quickly correct for these changes.
1. Press and hold the feature control button (A) for more than 9 seconds. When the compass memory is cleared, a "C" will appear in the display (B).
2. To calibrate the compass, drive the vehicle in 2 complete circles at less than 8 KPH (5 MPH).

Zone Map






Homelink

Description
The HomeLink Wireless control system provides a convenient way to replace up to three hand-held radio-frequency (RF) transmitters with a single built-in device. This innovative feature will learn the radio frequency codes of most current transmitters to operate devices such as gate operators, garage door openers, entry door locks, security systems, even home lighting.
Specification





Learn & Transmit Specification





** In case of OT(Original Transmitter) range < 80% of Transmission SPEC. It should be apply to transmission range for 80% of OT.
1. Follow the OT or OR(Original Receiver) about reception & transmission frequency.
2. Transmission Range means the distance from which the receiving device RF signal from HomeLink)
3. Reception Range means the distance within which the HomeLink can be trained with RF signal from OT.