Operation CHARM: Car repair manuals for everyone.
Home >> Hyundai >> 1989 >> Sonata L4-2.4L >> Repair and Diagnosis >> Powertrain Management >> Computers and Control Systems >> Testing and Inspection >> Reading and Clearing Diagnostic Trouble Codes
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Reading and Clearing Diagnostic Trouble Codes

Location Of Diagnostic Connector:





***UPDATED BY TSB# ENG016, APRIL, 1989
NOTE: In the event of a recurring check engine light accompanied by an oxygen sensor fault code, the probable cause is a poor alternator to engine ground, and excessive resistance in the battery ground circuit. For the recommended correction refer to TSB# ENG016.

Extracting fault codes.
1. Turn the ignition key `OFF'.
2. Connect the voltmeter to the self diagnosis connector.


Diagnostic Trouble Codes 11 - 22:




Diagnostic Trouble Codes 23 - 43:





NOTE: Do not disconnect the vehicle battery while the engine is running or while the ignition is on.
3. Turn the ignition key on and note the indication of the voltmeter. If the voltmeter indicates a steady 12 vdc the ECU has failed. If the voltmeter fluctuates, note the position and width of pulses and compare the pattern to the ECU codes chart to determine the error code.


4. After the cause of a failure code has been detected and corrected the diagnostic code memory of the ECU should be cleared by disconnecting the vehicle battery for 15 seconds or more.









pro multis · About Operation CHARM