Rear

1. Raise and support vehicle, then remove wheel and tire assembly.

Fig. 3 Exploded View Of Rear Disc Brake Assembly:

2. Remove trailing shoe key to anchor plate retaining screw, Fig. 3.
3. Press caliper assembly against leading shoe support key, then slide trailing shoe key outward.
4. Press caliper assembly against leading shoe key, then swing front end of caliper over anchor plate rail and hang caliper with wire.
5. Slide pads off caliper.
6. Bottom piston in caliper using suitable tool.
7. Install new pads, then the leading shoe key onto anchor plate.
8. Slide caliper assembly over disc, sliding trailing shoe key inboard until it is seated fully. Install trailing shoe key to anchor support screw.