Engine and Transaxle Installation

Installation is the reverse of removal, noting the following information:
1. While checking the connections of the harnesses, pipes, hoses, etc.., and ensuring that none of them is being caught, damaged, etc.., install the engine and transaxle assembly.






2. When the engine and transaxle assembly are in place, temporarily tighten the front roll stopper.






3. The front and rear center member rubber bushings and collars are different.
4. After the weight of the engine and transaxle assembly has been put on each insulator, tighten to specified torque.
5. Reassemble all of the components removed during disassembly. Be especially careful to properly secure all components, including fuel, electrical and fluid pipe connections.
. Refill the coolant and check for leaks.
7. Refill the transaxle fluid, test its operation, and check for leaks.
8. Check the operation of the transaxle control cable and accelerator cable. Adjust as necessary.
9. Check for proper operation of each of the various gauges.