Front

1. Use the special tool to remove and press in bushings A and B.




2. Press in bushing A and B so that the inner sleeve extends out by the standard value.

Standard value:
Bushing A: 9.2 - 10.2 mm (0.36 - 0.40 inch.)
Bushing B: 8.5 - 9.5 mm (0.33 - 0.35 inch.)

CAUTION: When pressing in, apply a solution of soap and water to the outside of the bushings, and then press them in one after the other. If there is a pause during the pressing operation, frictional resistance will prevent installation.