Automatic Transaxle Shift Control Components Installation
INSTALLATION1. Apply a coating of the specified grease to the interior of the adjust bushing.
Specified grease Chassis grease SAE J310, NLGI No.0
2. Move the shift lever and the transaxle range switch to the "N" position, and install the transaxle control cable.
3. When connecting the control cable to the transaxle mounting bracket, install the clip until it contacts the control cable, in the position shown in the illustration.
4. When connecting the control cable to the shift lever mounting bracket, install the clip until it contacts the control cable.
5. Install the cable mounting bolts.
6. Install the O/D switch to the selector knob.
7. Install the indicator.
8. Install the selector knob.
9. Insert the A/T shift lever connector pins correctly as shown in the illustration.
10. Connect the A/T shift lever connector and key lock switch connector.
11. Apply the specified grease at the places shown in the figure.
Specified grease Multipurpose grease SAE J310 NLGI No.2
12. Place the shift lever in the "N" position, and then turn the cam rod adjusting so that the clearance between the sleeve and the lever assembly end is within the standard value.
Standard value (A) 15.2 - 15.9 mm (0.598 0.625 in.)
13. Install the selector knob.
14. Install the console box.