Rear

Rear:

REMOVAL
1. Remove the wheel.





2. Check the pad thickness through the cylinder inspection hole. If the pad lining thickness is out of specification, replace the pads.
Pad inning thickness
Standard value: 11 mm (0.433 inch)
Service limit: 2.0 mm (0.079 inch)





3. Remove two bolts from the torque plate and remove the brake cylinder.





4. Remove the brake cylinder and suspend it with a wire.

NOTE: Do not disconnect the brake hose.





5. Remove the pads.

CAUTION: Be careful not to depress the brake pedal while disassembling the pads.

INSPECTION





1. Check the pads for wear or oil contamination and replace if necessary.

NOTE: The pads for the right and left wheels should be replaced at the same time.

Pad thickness wear limit: 2.0 mm
2. Check the leading and trailing shoe keys and retaining screw for damage, or wear. Replace the keys and retaining screw at the same time the pads are replaced.
3. Check for worn or damaged dust boots if dust or mud has entered the caliper assembly through this seal, the caliper assembly must be replaced or rebuilt.

INSTALLATION
1. Before replacing the brake pads, remove brake fluid from the master cylinder reservoir until it is half full.