Flywheel Components

DISASSEMBLY
1. Remove the transmission and clutch.
2. Remove the flywheel.

INSPECTION
1. Check the clutch disc contacting surface of the flywheel for damage and wear. Replace the flywheel if excessively damaged or worn.
2. Check the clutch disc contacting surface of the fly wheel for runout.
Standard value
Flywheel run-out: 0.1 mm (0.004 inch)
3. Check the ring gear for damage, crack and wear, and replace if necessary.

REASSEMBLY
Install the flywheel assembly and tighten the bolts to the specified torque.
Tightening torque
Flywheel bolt: 120 - 130 Nm (1200 - 1300 kg.cm, 90 - 96 ft. lbs.)