Rear Wheel Alignment

REAR WHEEL ALIGNMENT
TOE-IN
Standard value: 2 ± 2 mm

NOTE:
1. The assist arm mounting cam bolt (crossmember side) should be turned an equal amount on both sides when adjusting.
Inside direction of the vehicle: toe-in
Outside direction of the vehicle : toe-out





2. The scale has gradations of approximately 2.4 mm (14').

CAMBER
Standard value: -30' ± 30'

NOTE:
1. The rear suspension assembly must be free of worn, loose or damaged parts prior to measuring rear wheel alignment.
2. Camber is preset at the factory and cannot be adjusted.
3. If camber is not within the specifications, replace bent or damaged parts.