Rear Wheel Alignment
REAR WHEEL ALIGNMENTTOE-IN
Standard value:..............................4(+3,-1) mm (0.16(+0.12,-0.04) inch)
NOTE: Adjust the toe-in by fuming the tie rod end of the rear suspension arm.
Left tie rod:......Clockwise direction:.....toe-in
Right tie rod:......Clockwise direction:.....toe-out
A variation of toe by a rotation of the tie rod:......About 6 mm (0.6°)
The cam bolt should be adjusted to a maximum of 90° left or right from the center position.
CAUTION: After adjusting the tie rod, tighten both nuts to the specified torque.
Specified torque.................................0 - 60 Nm (500 - 600 kgf-cm, 37 - 43 ft. lbs.)