Operation CHARM: Car repair manuals for everyone.
Home >> Hyundai >> 2007 >> Entourage V6-3.8L >> Repair and Diagnosis >> Restraints and Safety Systems >> Air Bag Systems >> Impact Sensor >> Service and Repair >> Side Impact Sensor (SIS) >> Rear Side Impact Sensor
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Rear Side Impact Sensor

SIDE IMPACT SENSOR (SIS)

REAR SIDE IMPACT SENSOR

REMOVAL
1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2. Remove the rear pillar trim.
3. Disconnect the Slide Impact Sensor connector.




4. Remove the SIS mounting bolt then remove the Side Impact Sensor.

INSTALLATION
1. Be sure that the battery negative cable is disconnected.




2. Install the new Side Impact Sensor with the bolt then connect the SRS harness connector to the Side Impact Sensor.

Tightening torque : 1.0 - 1.4 kgf.m (9.5 - 13.6 Nm, 7.0 - 10.0 lb.ft)

3. Install the rear pillar trim.
4. Reconnect the battery negative cable.
5. After installing the Side Impact Sensor, confirm proper system operation: Turn the ignition switch ON, the SRS indicator light should be turned on for about six seconds and then go off.
pro multis · About Operation CHARM