Power Door Lock Actuator: Testing and Inspection

POWER DOOR LOCK ACTUATORS

INSPECTION

FRONT DOOR LOCK ACTUATOR
1. Remove the front door trim panel.
2. Disconnect the 7P connector from the actuator.






3. Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.






REAR DOOR LOCK ACTUATOR
1. Remove the rear door trim panel.
2. Disconnect the 7P connector from the actuator.






3. Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.






TRUNK LID RELEASE ACTUATOR
1. Remove the trunk lid trim panel.
2. Disconnect the 3P connector from the actuator.






3. Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.






FRONT DOOR LOCK SWITCH
1. Remove the front door trim panel.
2. Disconnect the 7P connector from the actuator.






3. Check for continuity between the terminals in each switch position according to the table.






REAR DOOR LOCK SWITCH
1. Remove the rear door trim panel.
2. Disconnect the 7P connector from the actuator.






3. Check for continuity between the terminals in each switch position according to the table.






TRUNK LID OPEN SWITCH
1. Remove the trunk lid trim panel.
2. Disconnect the 2P connector from the actuator.






3. Check for continuity between the terminals in each switch position according to the table.