Rear Bumper: Service and Repair

Replacement

Rear Bumper Cover Replacement

NOTE:
- After remove the rear combinati0n lamp.
- When prying with a flat-tip screwdriver, wrap it with protective tape , and apply protective tape around the related parts your hands.
- Put on gloves to protect your hands.
- Take care not bend or scratch the cover and other parts.

1. Remove the trunk trim.
2. Loosen the rear bumper cover screws and clips.
3. Remove the rear bumper cover (A).
4. Disconnect the connector.
5. Installation is the reverse of removal.

NOTE:
- Replace any damage clips.





Rear Bumper Rail Replacement
1. Remove the front bumper cover.
2. Remove the clips.
3. Remove the rear bumper rail (A).
4. Installation is the reverse of removal.

NOTE:
- Replace any damage clips.