Operation CHARM: Car repair manuals for everyone.
Home >> Hyundai >> 2009 >> Santa Fe FWD V6-3.3L >> Repair and Diagnosis >> Transmission and Drivetrain >> Automatic Transmission/Transaxle >> Transmission Temperature Sensor/Switch >> Service and Repair
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Transmission Temperature Sensor/Switch: Service and Repair





Removal

1. Remove the battery terminal.
2. Lift the vehicle.
3. Remove the splash shield.
4. Loosen the drain plug and drain the transaxle oil.
5. Remove the oil pan.
6. Disconnect the oil temperature sensor connector and remove the sensor(A) from the valve body.






Installation

1. Install the oil temperature sensor(A) and connect the sensor connector.

CAUTION:
When connecting the oil temperature connector, check the connector for rust, dirt, or oil, then reconnect it.




2. Continue to apply liquid gasket at application points at the oil pan with Ø0.098in(2.5mm) thickness.

Liquid gasket Part name : Threebond 1281B





3. Tighten the mounting bolt with the specified torque after installing the oil pan.

Tightening torque :
10 - 12Nm(1.0 - 1.2kgf.m, 7 - 8lb-ft)


4. Install the drain plug.

Tightening torque :
35 - 45Nm(3.5 - 4.5kgf.m, 25 - 32lb-ft)


5. Installation is the reverse of the removal.
pro multis · About Operation CHARM