Cylinder Block

Removal

CAUTION:
- Use fender covers to avoid damaging painted surfaces.
- To avoid damage, unplug the wiring connectors carefully while holding the connector portion.

NOTE:
- Mark all wiring and hoses to avoid misconnection.
- Inspect the timing belt before removing the cylinder head.
- Turn the crankshaft pulley so that the No.1 piston is at top dead center.
- Engine removal is required for this procedure.

1. Remove the exhaust manifold.
2. Remove the intake manifold.
3. Remove the timing chain.
4. Remove the water temperature control assembly.
5. Remove the cylinder head.
6. Remove the oil pump.
7. Remove the oil filter assembly.
8. Remove the A/C compressor(A) from engine.




9. Remove the alternator(A) from engine.




10. Remove the power steering pump from engine.


Installation

1. Install the power steering pump.
2. Install the alternator.
3. Install the air conditioner compressor
4. Install the oil filter assembly.
5. Install the oil pump.
6. Install the cylinder head.
7. Install the water temperature control assembly.
8. Install the timing chain.
9. Install the intake manifold.
10. Install the exhaust manifold.