Repair procedures

Replacement

CAUTION:
- Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
- Take care not to bend or scratch the trim and panels.
- Put on gloves to protect your hands.

1. Remove the rear seat assembly.

2. After loosening the mounting bolt, then remove the rear seat belt lower anchor (A).
[LH,RH]

Tightening torque :
39.2 - 53.9 N.m (4.0 - 5.5 kgf.m, 28.8 - 39.8 lb-ft)




[Center]

Tightening torque :
39.2 - 53.9 N.m (4.0 - 5.5 kgf.m, 28.8 - 39.8 lb-ft)




3. Using a screwdriver or remover, remove the rear pillar trim (A).




4. After loosening the mounting screws, then remove the luggage partition panel (A).




5. After loosening the mounting screws, then remove the rear package tray trim (A).




6. Installation is the reverse of removal.

NOTE:
- Make sure the connector are connected in properly.
- Replace any damaged clips.