Exterior Moulding / Trim: Service and Repair

Replacement

Roof Molding Replacement

NOTE:
- When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damaged.
- Put on gloves to protect your hands.
- Take care not to scratch the body surface.

1. Using a screwdriver or remover, remove the roof molding (A).




2. Installation is the reverse of removal.

NOTE:
- Replace any damage clips.

Trunk Lid Garnish Replacement

NOTE:
- When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damaged.
- Put on gloves to protect your hands.
- Take care not to scratch the body surface.

1. Remove the trunk lid trim.

2. After loosening the mounting nuts, then remove the rear combination lamp (A).




3. Using a screwdriver or remover, remove the trunk lid garnish (A).




4. Disconnect the connector (B).




5. Installation is the reverse of removal.

NOTE:
- Replace any damage clips.
- Make sure the trunk lid locks/unlocks and opens/closes properly.

Fender Garnish Replacement

NOTE:
- When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damaged.
- Put on gloves to protect your hands.
- Take care not to scratch the body surface.

1. Using a screwdriver or remover, remove the fender garnish (A).




2. Installation is the reverse of removal.

NOTE:
- Replace any damage clips.

Side Sill Garnish Replacement

NOTE:
- When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damaged.
- Put on gloves to protect your hands.
- Take care not to scratch the body surface.

1. Loosen the mounting screws.
2. Using a screwdriver or remover, remove the side sill garnish (A).
3. Installation is the reverse of removal.

NOTE:
- Replace any damage clips