Repair Procedures

Replacement

Sunvisor Replacement
1. After loosening the mounting screws, then remove the sunvisor (A) and retainer (B).




2. Installation is the reverse of removal.

Assist Handle Replacement
1. Remove the covers (A), and remove the screws, then remove the assist handle (B).




2. Installation is the reverse of removal.

Overhead Console Replacement
1. After loosening the mounting screws, then remove the overhead console assembly (A).




2. Push the lock pin (A), disconnect the connectors (B).




3. Installation is the reverse of removal.

NOTE:
- Make sure the connector is plugged in properly.

Room Lamp Replacement
1. Using a screwdriver, remove the cover (A).
2. After loosening the mounting screws, then remove the room lamp (B).
3. Disconnect the connector (C).




4. Installation is the reverse of removal.

NOTE:
- Make sure the connector is plugged in properly.

Vanity Lamp Replacement
1. Using a screwdriver, remove the vanity lamp (A).
2. Disconnect the connector (B).




3. Installation is the reverse of removal.

Roof Trim Assembly Replacement

NOTE:
- Put on gloves to protect your hands.
- When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
- Take care not to bend or scratch the trim and panels.

1. Remove the following items.
A. Sunvisor.
B. Overhead console.
C. Room lamp.
D. Assist handle.
2. Disconnect the cover (A) and ECM room mirror connector (B).




3. Disconnect the cover (A) and rain sensor connector (B).




4. Disconnect the wiring connector (A), mounting clips.

[Driver's]





[Passenger's]




5. Disconnect the antenna connector (A).




6. Disconnect the connector (B).
7. Disconnect the clips and then remove the roof trim (A).




8. Installation is the reverse of removal.

NOTE:
- Replace any damage clips.