Procedures

Service Adjustment Procedure

Transmission Oil Inspection And Replacement
1. After parking the vehicle on a plain, stop the engine.
2. After removing the oil filler plug and washer, inspect the manual transaxle fluid condition and quantity.
3. If the manual transaxle fluid is contaminated, drain it out by removing the oil drain plug.
4. Tighten the new oil drain plug and feed manual transaxle fluid to a proper level.

Tightening torque :
29.4 - 34.4 N.m(3.0 - 3.5kgf.m, 21.7 - 25.3lb-ft)
Oil type:SAE75W/85 or API GL-4
Oil quantity:
2.1L (0.14 U.S.gal., 0.55 U.S.qt., 0.46 lmp.qt.)

5. Retighten the oil filler plug with a new washer.

Tightening torque :
29.4 - 34.4 N.m(3.0 - 3.5kgf.m, 21.7 - 25.3lb-ft)

Back Up Lamp Switch Inspection
1. Disconnect the back up lamp switch connector(A).




2. Inspect the continuity of the switch. When the shift lever is located in reverse range, it should be applied an electric current.
3. Replace the back up lamp switch, if necessary.

Tightening torque :
29.4 - 34.4 N.m(3.0 - 3.5kgf.m, 21.7 - 25.3lb-ft)