Active Test

ACTIVE TEST

CAUTION:
^ Do not perform active test while driving.
^ Make sure to completely bleed air from the brake system.
^ The ABS and brake (EBD) warning lamps turn on during the active test.

Solenoid Valve Operation Chart

Solenoid Valve Operation Chart:

NOTE:
^ If active test is performed with brake pedal depressed, pedal stroke may change. This is normal.
^ TEST IS STOPPED is displayed approximately 10 seconds after operation starts.
^ After TEST IS STOPPED is displayed, to perform test again, repeat Step 6.

ABS Motor
Touch ON and OFF on the screen. Check that ABS motor relay operates as shown in table.








NOTE:
^ If active test is performed with brake pedal depressed, pedal stroke may change. This is normal.
^ TEST IS STOPPED is displayed approximately 10 seconds after operation starts.

Booster Drive

CAUTION: Perform active test subject to the conditions below.
^ Do not operate brake pedal during active test.
^ Make sure the engine revolution is over 500 rpm.
^ Make sure the vehicle is not moving.

Touch "UP" and "DOWN" on the screen. Check that booster drive operates as shown in table.








NOTE: "TEST IS STOPPED" is displayed approximately 10 seconds after operation starts.