Door Lock - Remote Transmitter Programming

Models: 1993 J30

Section: Body & Frame

Classification: BF92-008

Bulletin No.: ITB92-044

Date: August 21, 1992

J30 REMOTE TRANSMITTER PROGRAMMING

APPLIED MODELS: 1993 Infiniti J30 (JPY32)

SERVICE INFORMATION

The proper procedure for programming additional remote controllers is listed below.

SERVICE PROCEDURE:

While sitting inside the vehicle:

(1) Open the trunk.

(2) Close and lock all doors using the power door lock switch.

(3) Insert and remove the key from the ignition six times within 10 seconds.

(4) Unlock and lock doors once using the power door lock switch to enable "setting" mode.

(5) Push lock button on the new remote controller once, just long enough to hear it beep, within 5 seconds of completing step 4.

(6) If additional remotes are needed (up to 3), repeat steps 4 and 5 only for each additional remote immediately after programming the first remote (Note: a total of four (4) remotes can be programmed to function on the same vehicle).

For additional information, please refer to page BF-38 of Service Manual.