Action Test
ICC system running testICC SYSTEM SET CHECKING
1. Turn on the ON/OFF switch.
2. Drive the vehicle between 25 MPH (40 km/h for CANADA models) and 90 MPH (144 km/h for CANADA models).
3. Push the COAST/SET switch.
4. Confirm that the desired speed is set as hand is released from the COAST/SET switch.
NOTE:
- When there is no vehicle ahead, drive at the set speed steadily.
- When there is a vehicle ahead, control to maintain distance from the vehicle ahead, watching its speed.
- The set vehicle speed is displayed on the ICC system indicator in the combination meters.
CHECK FOR INCREASE OF THE CRUISING SPEED
1. Set the ICC at desired speed.
2. Check if the set speed increases by 1 MPH (1 km/h for CANADA models) as ACCELERATE/RESUME switch is pushed.
NOTE: The maximum set speed of the ICC system is 90 MPH (144 km/h for CANADA models).
CHECK FOR DECREASE OF THE CRUISING SPEED
1. Set the ICC at desired speed.
2. Check if the set speed decreases by 1 MPH (1 km/h for CANADA models) as COAST/SET switch is pushed.
NOTE:
- ICC system is automatically turned off when the driving speed lowers to 20 MPH (32 km/h for CANADA models) due to the deceleration of the vehicle ahead.
- The lowest set speed is 25 MPH (40 km/h for CANADA models).
CHECK FOR THE CANCELLATION OF ICC SYSTEM (NORMAL DRIVING CONDITION) IN THE FOLLOWING CASES:
1. When the brake pedal is depressed after the system is turned on.
2. When the select lever is shifted into other than "D" including manual shift.
3. When the ON/OFF switch is turned off.
4. When CANCEL switch is operated.
CHECK FOR RESTORING THE SPEED THAT IS SET BY ICC SYSTEM BEFORE ICC CANCELLATION
1. Cancel the system by depressing the foot brake.Then, check that the speed before cancellation is restored when pressing ACCELERATE/RESUME switch with 25 MPH (40 km/h for CANADA models) or above.
2. Cancel the system by shifting the select lever into other than "D", Then, check if the speed set before the cancellation is restored when ACCELERATE/RESUME switch is pressed.
3. Check if the speed previously set is restored when ACCELERATE/RESUME switch is operated with driving 25 MPH (40 km/h for CANADA models), after canceling the ICC by operating the CANCEL switch.
CHECK FOR ON/OFF SWITCH
1. Start the engine.Then, check the following operations are carried correctly.
2. Intelligent Cruise Control (ICC) system is displayed in between the tachometer and speedometer illuminates when ON/OFF switch is ON and ready for operation.The illumination goes off when ON/OFF switch is turned to OFF.
3. "CRUISE" illumination and "ICC" system illumination go off when the key switch is turned to OFF while ON/OFF switch is ON ("CRUISE" illumination is ON and ICC system is ready for operation).
CHECK FOR ACCEL/RES, COAST/SET, CANCEL SWITCHES
1. Check if ACCELERATE/RESUME, COAST/SET, CANCEL switches are operated smoothly.
2. Check if buttons come up as hand is released from the buttons.
CHECK FOR DISTANCE SWITCH
1. Start the engine.
2. Turn on the ON/OFF switch.
3. Press the DISTANCE switch.
4. Check if the set distance indicator changes display in order of: (long) -> (middle) -> (short).
NOTE: The set distance indicator shows 'long' immediately after the engine starts.