Precautions For Assembly and Installation

Precautions for Assembly and Installation
Use torque wrench to tighten bolts or nuts.
When tightening nuts and bolts, as a basic rule, equally tighten in several different steps starting with the ones in center, then ones on inside and outside diagonally in this order. If the order of tightening is specified, do exactly as specified.

Replace with new gasket, packing, oil seal or 0-ring.
Thoroughly wash, clean, and air-blow each part. Carefully check oil or coolant passages for any restriction and blockage.

Avoid damaging sliding or mating surfaces. Completely remove foreign materials such as cloth lint or dust. Before assembly, oil sliding surfaces well.

Release air within route after draining coolant.
After repairing, start engine and increase engine speed to check coolant, fuel, oil, and exhaust systems for leakage.