A/T Does Not Shift: D2 -> D1

A/T Does Not Shift: 2nd gear -> 1st gear

SYMPTOM: When shifted from 2M to 1M position in manual mode, does not downshift from 2nd to 1st gear.

DIAGNOSTIC PROCEDURE
1. CHECK SELF-DIAGNOSTIC RESULTS
Execute self-diagnosis.

Do the self-diagnostic results indicate PNP switch, ATF pressure switch 5?
YES >> Check the malfunctioning system. Refer to "DTC P0705 PARK/NEUTRAL POSITION SWITCH", "DTC P1845 ATF PRESSURE SWITCH 5". P0705 P1845
NO >> GO TO 2.

2. CHECK A/T FLUID LEVEL





Check A/T fluid level again.

OK or NG
OK >> GO TO 3.
NG >> Refill ATF.

3. CHECK CONTROL LINKAGE





Check the control linkage.
^ Refer to "Checking of A/T Position".

OK or NG
OK >> GO TO 4.
NG >> Adjust control linkage. Refer to "Adjustment of A/T Position".

4. MANUAL MODE SWITCH
Check the manual mode switch. Refer to "DTC P1815 MANUAL MODE SWITCH". P1815

OK or NG
OK >> GO TO 5.
NG >> Repair or replace damaged parts.

5. CHECK A/T FLUID CONDITION
1. Remove oil pan.





2. Check A/T fluid condition.

OK or NG
OK >> GO TO 6.
NG >> GO TO 9.

6. DETECT MALFUNCTIONING ITEM
^ Check the malfunction items. If any items are damaged, repair or replace damaged parts. Refer to "Symptom Chart". Symptom Chart

OK or NG
OK >> GO TO 7.
NG >> Repair or replace damaged parts.

7. CHECK SYMPTOM
Check again.

OK or NG
OK >> INSPECTION END
NG >> GO TO 6.

8. PERFORM TCM INSPECTION
1. Perform TCM input/output signal inspection.
2. If NG, recheck TCM pin terminals for damage or loose connection with harness connector.

OK or NG
OK >> INSPECTION END
NG >> Repair or replace damaged parts.

9. DETECT MALFUNCTIONING ITEM
^ Check the malfunction items. If any items are damaged, repair or replace damaged parts. Refer to "Symptom Chart".

OK or NG
OK >> GO TO 7.
NG >> Repair or replace damaged parts.