Disassembly and Assembly
FRONT WHEEL HUB AND KNUCKLEDisassembly and Assembly
DISASSEMBLY
CAUTION: Do not disassemble if wheel bearing has no trouble.
1. Use a flat-bladed screwdriver or similar tool to remove Grease seal from wheel hub.
2. Using a puller (suitable tool), drift (suitable tool), and bearing replacer (suitable tool), press wheel hub out to remove from ABS sensor rotor.
3. Using a snap ring plier or similar tool to remove snap ring from wheel hub.
4. Using a drift (special service tool), press to remove wheel bearing from wheel hub.
ASSEMBLY
1. Using a drift (suitable tool) as shown in the figure, press wheel bearing into wheel hub.
CAUTION:
^ Discard old wheel bearing; replace with new one.
^ Do not press inner race of wheel bearing assembly.
^ Do not apply oil or grease to mating surfaces of wheel bearing outer race and wheel hub.
NOTE: Final press load guideline 29,420 N (3,000 kg, 6,614 lbs.)
2. Using a drift (special service tool), press ABS sensor rotor into wheel hub.
Tool number: ST15310000 (J 25640-B)
CAUTION: Discard old ABS sensor rotor; replace with new one.
3. Using a snap ring plier or similar tool, install snap ring into wheel hub.
4. As shown in the figure, securely press-fit grease seal until hub end surface "N" and grease seal flange surface "M" are completely fitted.
Pressure: 9,806 N (1,000 kg, 2,204 lbs.) or less.
CAUTION: Discard old grease seal; replace with new one.