Lock-Up Is Not Released

Lock-up Is Not Released

SYMPTOM: The lock-up condition cannot be cancelled.

DIAGNOSTIC PROCEDURE
1. CHECK SELF-DIAGNOSIS RESULTS
Perform self-diagnosis.

Do the self-diagnosis results indicate torque converter clutch solenoid valve, engine speed signal, turbine revolution sensor, CAN communication?
YES >> Check the malfunctioning system. Refer to "DTC P0740 TORQUE CONVERTER CLUTCH SOLENOID VALVE", "DTC P0725 ENGINE SPEED SIGNAL", "DTC P1716 TURBINE REVOLUTION SENSOR", "DTC U1000 CAN COMMUNICATION LINE".
P Code Charts

NO >> GO TO 2.

2. CHECK SYMPTOM
Check again.

OK or NG
OK >> INSPECTION END
NG >> GO TO 3.

3. CHECK TCM
Perform TCM input/output signal inspection.

OK or NG
OK >> INSPECTION END
NG >> GO TO 4.

4. DETECT MALFUNCTIONING ITEM
Check the following items:
^ Power supply and ground circuit for TCM.
^ A/T assembly harness connector pin terminals for damage or loose connection with harness connector.

OK or NG
OK >> Replace the transmission assembly.
NG >> Repair or replace damaged parts.