With Manufacturer's Scan Tool

CONSULT-II Function (A/T)
CONSULT-II can display each diagnostic item using the diagnostic test modes shown following.





FUNCTION

CONSULT-II REFERENCE VALUE








NOTICE:
1. The CONSULT-II electrically displays shift timing and lock-up timing (that is, operation timing of each solenoid).
Check for time difference between actual shift timing and the CONSULT-II display. If the difference is noticeable, mechanical parts (except solenoids, sensors, etc.) may be malfunctioning. Check mechanical parts using applicable diagnostic procedures.
2. Shift schedule (which implies gear position) displayed on CONSULT-II and that indicated in Service Manual may differ slightly. This occurs because of the following reasons:
^ Actual shift schedule has more or less tolerance or allowance,
^ Shift schedule indicated in Service Manual refers to the point where shifts start, and
^ Gear position displayed on CONSULT-II indicates the point where shifts are completed.
3. Display of solenoid valves on CONSULT-II changes at the start of shifting, while gear position is displayed upon completion of shifting (which is computed by TCM).

CONSULT-II SETTING PROCEDURE

CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which perform CAN communication.

^ For details, refer to the separate CONSULT-II Operations Manual.





1. Turn ignition switch OFF.
2. Connect CONSULT-II and CONSULT-II CONVERTER to data link connector, which is located in instrument lower driver panel on driver side.
3. Turn ignition switch ON. (Do not start engine.)





4. Touch START (NISSAN BASED VHCL).





5. Touch A/T.
If A/T is not indicated, go to GI-38, CONSULT-II Data Link Connector (DLC) Circuit. Data Link Connector Schematic





6. Perform each diagnostic test mode according to each service procedure.

SELF-DIAGNOSTIC RESULT MODE
After performing self-diagnosis, place check marks for results on the DIAGNOSTIC WORKSHEET. Work Flow Reference pages are provided following the items.

Operation Procedure
1. Perform CONSULT-II SETTING PROCEDURE.





2. Touch SELF-DIAG RESULTS. Display shows malfunction experienced since the last erasing operation.











Display Items List

How to Erase Self-diagnostic Results





1. Perform CONSULT-II SETTING PROCEDURE.
2. Touch SELF-DIAG RESULTS.





3. Touch ERASE. (The self-diagnostic results will be erased.)

DATA MONITOR MODE
Operation Procedure





1. Perform CONSULT-II SETTING PROCEDURE.
2. Touch DATA MONITOR.

NOTE: When malfunction is detected, CONSULT-II performs REAL-TIME DIAGNOSIS. Also, any malfunction detected while in this mode will be displayed at real time.














Display Items List

CAN DIAGNOSTIC SUPPORT MONITOR MODE
Operation Procedure





1. Perform CONSULT-II SETTING PROCEDURE.
2. Touch CAN DAIG SUPPORT MNTR. Refer to Precautions When Using CONSULT-II.

DTC WORK SUPPORT MODE
Operation Procedure





1. Perform AT-94, CONSULT-II SETTING PROCEDURE.
2. Touch DTC WORK SUPPORT.





3. Touch select item menu.





4. Touch START.





5. Perform driving test according to DTC Confirmation Procedure in TROUBLE DIAGNOSIS FOR DTC.





^ When testing conditions are satisfied, CONSULT-II screen changes from OUT OF CONDITION to TESTING.





6. Stop vehicle.





^ If NG appears on the screen, malfunction may exist. Go to Diagnostic Procedure.





7. Perform test drive to check gear shift feeling in accordance with instructions displayed.
8. Touch YES or NO.
9. CONSULT-II procedure is ended.





^ If NG appears on the screen, a malfunction may exist. Go to DIAGNOSTIC PROCEDURE.





Display Items List