System Specifications
Timing Chain TensionerComponents:
Components:
Crankshaft Pulley
Torque 44.1 Nm (4.5 kg-m, 33 ft. lbs.)
Put a paint mark on crankshaft pulley aligning with angle mark on crankshaft pulley bolt. Then, further retighten bolt by 60 degrees (Angle tightening).
Rotate crankshaft pulley in normal direction (clockwise when viewed from front) to confirm it turns smoothly.
Timing Cover
Tighten mounting bolts to the specified torque in numerical order as shown in the figure.
There are two type of mounting bolts. Refer to the following for locating bolts.
M8 bolts: 1, 2
Torque 28.4 Nm (2.9 kg-m, 21 ft. lbs.)
M6 bolts: Except the above
Torque 12.7 Nm (1.3 kg-m, 9 ft. lbs.)
After all bolts tightened, retighten them to the specified torque in numerical order as shown in the figure.