Transmitter ID Registration Procedure

ID Registration Procedure
ID REGISTRATION WITH ACTIVATION TOOL
This procedure must be done after replacement of a transmitter or BCM.
1. Perform "CONSULT-II Start Procedure". Refer to GI-37, "CONSULT-II Start Procedure". With Manufacturer's Scan Tool
2. Touch "WORK SUPPORT" on "SELECT DIAG MODE" screen, and select "ID REGIST".








3. With the activation tool (J-45295) pushed against the front-left transmitter position of the tire air valve, press the button then keep 5 seconds.
4. Register the IDs in order from FR LH, FR RH, RR RH to RR LH. When ID registration of each wheel has been completed, turn signal lamp (LH/RH) blinks.
5. After completing all ID registrations, press "END" to complete the procedure.

NOTE: Be sure to register the IDs in order from FR LH, FR RH, RR RH, to RR LH, or the self-diagnostic results display will not function properly.

ID REGISTRATION WITHOUT ACTIVATION TOOL
This procedure must be done after replacement of a transmitter or BCM.
1. Perform "CONSULT-II Start Procedure". Refer to GI-37, "CONSULT-II Start Procedure". With Manufacturer's Scan Tool
2. Touch "WORK SUPPORT" on "SELECT DIAG MODE" screen, and select "ID REGIST".
3. Adjust the tire pressure to the values shown in the table for ID registration, and drive the vehicle at 40 km/h (25 MPH) or more for a few minutes.





4. After completing all ID registrations, press "END" to complete the procedure.





5. Inflate all tires to proper pressure.