Auto Active Test

Auto Active Test

DESCRIPTION
In auto active test mode, operation inspection can be performed when IPDM E/R sends a drive signal to the following systems:
- Rear window defogger
- Front wiper (LO, HI)
- Tail lamps, parking lamps and license plate lamps
- Front fog lamps
- Headlamps (LO, HI)
- A/C compressor (magnetic clutch)
- Cooling fan
- Oil pressure warning lamp

OPERATION PROCEDURE
1. Close hood and front door (passenger side), and then lift wiper arms away from windshield (to prevent glass damage by wiper operation).

NOTE: When auto active test is performed with hood opened, sprinkle water on windshield beforehand.

2. Turn ignition switch OFF.
3. Turn ignition switch ON, and within 20 seconds, press driver's door switch 10 times (close other doors). Then turn ignition switch OFF.
4. Turn ignition switch ON within 10 seconds after ignition switch OFF.
5. When auto active test mode is actuated, horn chirps once. Oil pressure warning lamp starts blinking.
6. After a series of operations is repeated three times, auto active test is completed.

NOTE: When auto active test mode has to be cancelled half way, turn ignition switch OFF.

CAUTION:
- Never start the engine.
- If the engine starting operation is made, delete DTC on the self-diag results of CONSULT-II. Refer to BL-79, "CONSULT-II Application Items". Testing and Inspection
- Be sure to inspect GW-50, "Check door Switch" when the auto active test cannot be performed. Windows and Glass




INSPECTION IN AUTO ACTIVE TEST MODE










Concept of Auto Active Test
- IPDM E/R actuates auto active test mode when it receives door switch signal from BCM via CAN communication line. Therefore, when auto active test mode is activated successfully, CAN communication between IPDM E/R and BCM is normal.
- If any of systems controlled by IPDM E/R cannot be operated, possible cause can be easily diagnosed using auto active test.