Front

REMOVAL OF SEAT BELT RETRACTOR
1. Remove the outer anchor.
- Remove the belt tension sensor cover and cover protector (passenger side only).
- Disconnect the belt tension sensor connector (passenger side only).
- Remove the fixing bolt of the outer anchor.

2. Remove the shoulder anchor.
- Remove the center pillar lower and upper garnishes, refer to "BODY SIDE TRIM".
- Remove the fixing anchor nut of the shoulder anchor.

3. Remove the seat belt assembly.




- Disconnect the seat belt pre-tensioner connector.

CAUTION:
- For installing/removing seat belt pre-tensioner connector, insert thin screwdriver wrapped in tape into notch, lift lock and remove connector.
- Install connector with lock raised, and push lock into connector.

- Disconnect the pre-crush seat belt connector (for only the vehicle with pre-clash seat belt).
- Remove the fixing screw and anchor bolt of the pre-tensioner seat belt retractor.

INSTALLATION OF SEAT BELT RETRACTOR
- Install in the reverse order of removal.
- Tighten by specified torque.

Tightening torque: 49.0 N.m (5.0 kg-m, 36 ft-lb)