Accelerator Pedal Position Sensor: Service and Repair

ON-VEHICLE REPAIR

ACCELERATOR CONTROL SYSTEM

Exploded View

ACC-3 Exploded View:

Removal and Installation

REMOVAL
1. Remove the bolt cap and the inside mounting bolt.
2. Remove accelerator pedal assembly.
3. Disconnect accelerator pedal position sensor harness connector.

CAUTION:
- Never disassemble accelerator lever. Never remove accelerator pedal position sensor from accelerator lever.
- Avoid impact from dropping etc. during handling.
- Be careful to keep accelerator lever away from water.

INSTALLATION
Installation is the reverse order of removal.

Inspection

INSPECTION AFTER INSTALLATION
- Check accelerator pedal moves smoothly within the whole operation range when it is fully depressed and released.
- Check accelerator pedal securely returns to the fully released position.
- For the electrical inspection of accelerator pedal position sensor, refer to EC-421, "Description" P2122, EC-425, "Description" P2127 and EC-430, "Description" P2138.

CAUTION: When harness connector of accelerator pedal position sensor is disconnected, perform Accelerator Pedal Released Position Learning. Refer to EC-17, "ACCELERATOR PEDAL RELEASED POSITION LEARNING : Description" Testing and Inspection.