Consult-III Function (All Mode AWD/4WD)
CONSULT-III Function (ALL MODE AWD/4WD)FUNCTION
SELF-DIAG RESULT MODE
^ Drive at 30 km/h or more for approximately 1 minute before performing the self-diagnosis.
Display Item List:
How to Erase Self-Diagnostic Results
^ Before erasing DTC memory, start the engine and drive at 30 km/h or more for approximately 1 minute. Check that ABS warning lamp turns OFF.
NOTE: Make sure that ABS warning lamp turns OFF by driving for a minute at vehicle speed of 30 km/h (19 MPH) or more after turning ignition switch OFF if AWD warning lamp turns ON with system malfunction of "ABS SYSTEM [C1203]". AWD warning lamp may not turn OFF if it is normal unless ignition switch turns OFF at once and engine restarts after that.
DATA MONITOR MODE
Display Item List:
ACTIVE TEST MODE
Description
^ Use this mode to determine and identify the details of a malfunction based on self-diagnostic results or data monitor. AWD control unit gives drive signal to actuator when receiving command from CONSULT-III to check operation of actuator.