System Specifications

EM-64 Component (Part 1):

EM-64 Component (Part 2):

Timing Chain Tensioner

Crankshaft Pulley
Tighten crankshaft pulley bolt.
Tightening torque 44.1 Nm (4.5 kg-m, 33 ft-lb)





Place a paint mark (A) on crankshaft pulley (1) aligning with the angle mark (B) on crankshaft pulley bolt (2). Tighten the bolt 90 degrees (angle tightening).
Rotate crankshaft pulley in normal direction (clockwise when viewed from front) to confirm it turns smoothly.

Timing Cover





Tighten mounting bolts to the specified torque in numerical order as shown in the figure.
There are two types of mounting bolts. Refer to the following for locating bolts.
M8 bolts 1, 2
Tightening torque 28.4 Nm (2.9 kg-m, 21 ft-lb)
M6 bolts Except the above
Tightening torque 12.7 Nm (1.3 kg-m, 9 ft-lb)
After all bolts tightened, retighten them to the specified torque in numerical order as shown in the figure.