Procedures

REAR REGULATOR


Inspection and Adjustment


SYSTEM INITIALIZATION OF ANTI-PINCH SYSTEM
If any of the following work has been done, initialize the system. Description.

Initialization
After installing each component to the vehicle, follow the steps below. Work Procedure.

FITTING INSPECTION
- Check that the glass is securely fit into the glass run groove.
- Lower the glass slightly [approximately 10 to 20 mm (0.394 to 0.787 in)], and check that the clearance to the sash is parallel. If the clearance between the glass and sash is not parallel, loosen the regulator mounting bolts, guide rail mounting bolts, and glass and carrier plate mounting bolts to correct the glass position.