Removal and Installation

BACK DOOR


BACK DOOR ASSEMBLY : Removal and Installation


CAUTION:
- Operate with two workers, because of its heavy weight.
- Use protective tape or cloth to protect from damage during remove and installation.

REMOVAL
1. Remove stud ball of back door support rod. Back Door Support Rod.
2. Remove roof garnish. Removal And Installation.





3. Disconnect back door harness connectors (A) and remove back door harness clip (B).
4. Remove back door harness grommet, and then pull harness out of vehicle through roof panel hole.
5. Disconnect washer tube.
6. Remove washer tube grommet, and then pull washer tube out of vehicle through roof panel hole.
7. Support back door lock with the proper material to prevent it from falling.

WARNING:
Body injury may occur if no supporting rod is holding the back door open when removing the back door stay.
8. Remove back door stay. Service and Repair.
9. Remove back door hinge mounting nuts on back door and remove back door assembly.

INSTALLATION
Note the following items, and then install in the reverse order of removal.

CAUTION:
- Apply anticorrosive agent onto the mounting surface.
- Check back door open/close, lock/unlock operation after installation.
- After installation, perform fitting adjustment. Adjustments.